Thank you for your purchase of Ikelite equipment. Please read thisinstruction manual completely before attempting to operate or dive with thisproduct.
10LubricantIkelite provides silicone lubricant with the housing. We recommend you useonly Ikelite lubricant on Ikelite products. Other brands may caus
11- Rinse the housing exterior thoroughly in freshwater after each saltwateruse. Move each push button in and out several times to release trappedsalt
12- Do not shoot down on subjects as they will quite often blend into thebackground and be difficult to see in the photograph. Shoot subjectsstraight
13TroubleshootingWater enters thehousing - Remove, clean and properly lubricate the main o-ring.- Look for hairs, dirt, or foreign debris c
14ProblemSolutionFogging occurs onthe Lens Port- Humid air is trapped inside the housing. The camera produces heat and may condense any tra
15Push buttons orcontrols are stickyand hard to operate - Remove the camera and rinse the closed housing in freshwater. Vigorously press each pus
16External StrobesA separate external strobe adds color to restore the warmer colorsfiltered out by the water as well as to illuminate the subject. Ad
17Accessory Lens InformationPlease refer to the “supplemental instructions” manual for AccessoryLens information. UR/Pro Filter (Blue Water) The UR/Pr
Returning Products for Service (outside the United States)For the separate international customs documentation form that youcomplete to accompany the
This Ikelite product is warranted against any manufacturing defects for aperiod of one (1) year from the original date of purchase. Defectiveproducts
2Table of ContentsPackage Contents ...P. 3Preparation ...
ULTRAcompact_General_07-0712Ikelite Underwater Systems50 West 33rd StreetIndianapolis, IN 46208 USAwww.ikelite.comProduct RegistrationPlease visit www
3This product has been water pressure tested at the factory and is depthrated to 200 ft. (60m). Thoroughly inspect and immerse the emptyhousing comple
PUSH TOUNLOCK4LatchButtonLatchButtonSide ViewLatch ClosedDiagram ATop ViewLatch OpenedLatch in FULLYopen positionDiagram B Initial Camera Setup (for
5 Closing the HousingRotate the hinged back onto the housing front. Close the latch and makesure it locks. Latch will “click” into it’s locked positi
6Using the Camera’s Built-in FlashIf you are shooting with the camera’s built-in flash and the cameras lensis set to the widest angle, you may need to
7The diffuser should be installed when using the camera flash. Whenshooting close-up photographs with the camera flash and at the cameralens’s widest
8Entering the WaterAs soon as you enter the water, take a moment and check the housingto see that it is properly sealed.Next, check to see if there ar
9Diagram EO-ring MaintenanceWe recommend that you clean the main housing o-ring and mainhousing o-ring channel before each day of diving.1. To remove
Comments to this Manuals